Bronkhorst Modbus slave interface Manuale Utente Pagina 7

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 6
BRONKHORST®
1 8
2 FIELD BUS INSTALLATION
2.1 General
Modbus is a 3-wire, RS485-based field bus communication system for parameter value exchange. In this system each
instrument / device is equipped with a micro-controller for its own dedicated task but also for exchanging parameter
value information with other instruments / devices connected to the same Modbus system.
The implementation of the Modbus interface is based on the following standards:
[1] Modbus_Application_Protocol_V1_1b.pdf December 28, 2006
[2] Modbus_over_serial_line_V1_02.pdf December 20, 2006
Physical layer and communication protocol are detected automatically upon reception of messages.
These messages must be sent using the correct combination of physical layer and communication
protocol. After every power-up the communication detection mode is active.
Bronkhorst advices not to use more as 127 instruments in one bus system.
2.2 Modbus connector
2.2.1 Shielded RJ45 modular jack
Warning: this device uses a vendor specific pin layout on the RJ45 connector that differs from the
Modbus recommended pin layout.
The shielded RJ45 modular jack connector (for non IP65 applications) has the following pin configuration:
RJ45 Connector
Receptable
Pin number
Description
1 +15…24Vdc supply
2 0V
3 Shield
4 0V
5
+15…24Vdc supply
6 0V (Modbus common)
7 D0 Modbus (A/A')
8 D1 Modbus (B/ B')
The maximum contact rating for RJ45 connectors is 1.5A.
For MASS-VIEW instrument see manual 9.17.051 for pin layout.
http://www.bronkhorst.com/en/downloads/instruction_manuals/
Page 7 Modbus interface 9.17.035
Vedere la pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Commenti su questo manuale

Nessun commento

Mueller 12x15 (D.I.Y.) with Optional Center Girts and Floo Handbücher

Bedienungsanleitungen und Benutzerhandbücher für Spezialmaschinen Mueller 12x15 (D.I.Y.) with Optional Center Girts and Floo.
Wir stellen 1 PDF-Handbücher Mueller 12x15 (D.I.Y.) with Optional Center Girts and Floo zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung






Weitere Produkte und Handbücher für Spezialmaschinen Mueller

Modelle Dokumententyp
12x21 (D.I.Y.) with Optional Center Girts and Floo Bedienungsanleitung   Mueller 12x21 (D.I.Y.) with Optional Center Girts and Floor Kit User Manual, 31 Seiten
18x21 (D.I.Y.) with Optional Center Girts and Floo Bedienungsanleitung   Mueller 18x21 (D.I.Y.) with Optional Center Girts and Floor Kit User Manual, 32 Seiten
24x24 (D.I.Y.) with Optional Center Girts and Floo Bedienungsanleitung   Mueller 24x24 (D.I.Y.) with Optional Center Girts and Floor Kit User Manual, 33 Seiten
12x21 DIY KIT FOR SLAB Bedienungsanleitung   Mueller 12x21 DIY KIT FOR SLAB User Manual, 25 Seiten
12x21 (DIY) with Optional Center Girts Bedienungsanleitung   Mueller 12x21 (DIY) with Optional Center Girts User Manual, 28 Seiten
18x21 DIY KIT FOR SLAB Bedienungsanleitung   Mueller 18x21 DIY KIT FOR SLAB User Manual, 23 Seiten
24x24 DIY KIT FOR SLAB Bedienungsanleitung   Mueller 24x24 DIY KIT FOR SLAB User Manual, 24 Seiten
6x9 D.I.Y. Greenhouse Bedienungsanleitung   Mueller 6x9 D.I.Y. Greenhouse User Manual, 23 Seiten
9x12 D.I.Y. Greenhouse Bedienungsanleitung   Mueller 9x12 D.I.Y. Greenhouse User Manual, 23 Seiten
12x15 D.I.Y. Greenhouse Bedienungsanleitung   Mueller 12x15 D.I.Y. Greenhouse User Manual, 23 Seiten
12x18 D.I.Y. Greenhouse Bedienungsanleitung   Mueller 12x18 D.I.Y. Greenhouse User Manual, 23 Seiten
Wildlife Guzzler Bedienungsanleitung   Mueller Wildlife Guzzler User Manual, 17 Seiten
Cold Form Endwall Bedienungsanleitung   Mueller Cold Form Endwall User Manual, 11 Seiten
W300 Windlock Clip Bedienungsanleitung   Mueller W300 Windlock Clip User Manual, 1 Seiten